Tiles Bulging Off Wall

B replace the removed tiles with a large mirror c force the wall back in with some type of ugly metal alloy strip screwed in over the top of the tiles and into the stud.

Tiles bulging off wall.

I feel this in conjunction with skinned over adhesive is the root cause of your tile failure. As ceramic tile get larger the wall or floor surface must be flatter and flatter. Make sure that the tile adhesive that you use is water resistant. The chalk dust will stop the tiles from adhering to the wall.

If no adhesive is applied then the tiles will fall off. The wall isn t hot to touch difficult one to answer as obviously the shower is running at the time but the problem does occur on the side of the hot water upright feed each time. Damage to a subfloor is one of the most common reasons for a tile to bulge or lift from the subfloor according to the american society of home inspectors. Since the tile is flat and in the same plane the wall surface must also be a perfect match.

Any low spots on the subfloor can cause a tile to bulge. Tiles need to adhere to a smooth undamaged surface. A pull down that section of wall and re tile with new blue board etc although the current old tiles cannot again be sourced to match the exisiting. Grouting has been done too early.

A buckling or partly raised tile on your shower wall usually means water has gotten behind the tile often through cracks in the grout and caused the wall material to expand pushing the tile outward. The subfloor must be clean even and dry before tile installation. Adhesive has not been applied properly.