Remove the screen door from the frame by grasping it on both sides and lifting the rollers off the lower track.
Tilt and slide doors falling off.
Align it in the bottom track and then tilt it up.
Give the screw a clockwise turn and test to see whether the door slides easier.
If the door becomes even harder to open turn the screw in the opposite direction.
Lift a bottom supported door such as an sliding glass patio door straight up to clear the bottom track.
Tilt and slide door repairing.
After a bit of adjustment the door should roll easily without rubbing on the bottom track.
Then sharply angle the bottom of the door outward and lift the door from the track.
Angle the bottom toward you and lift it a little further to disengage the runners on the upper track then pull it out of the doorway.
If an off track roller isn t the problem you ll have to remove the doors to adjust and possibly replace the rollers.
Step 2 lay the door on a flat surface and tighten the screws in all four corners.
The unique sash design tilts and slides parallel to the fixed unit with the touch of a finger.
Do this with a helper.
Fabricated from our system 4500 line this design is a premium door solution for spaces that do not allow for traditional inswing doors.
Roll the door toward the latch side jamb then turn the adjustment screws until the door is parallel with the jamb.
You may also want to check out our step by step guideto adjusting your sliding doors.
Reattach the head stop first otherwise it could fall out.
Sometimes one roller falls out of the track and the bottom edge of the door skids along the lower rail.
To remove a bottom supported sliding door lift and then tilt the bottom out of the track.